Avoiding these six common errors can save time, reduce the risk of invalid data, and help prevent repeated testing.

Mistake #1: Accidentally using incorrect settings for a sensor

A simple mistake, such as having the decimal point in the wrong place when you manually enter a sensor’s “output sensitivity” or forgetting to enable the 200V polarization voltage that may be needed for a microphone, can ruin your results. It can be difficult, if not impossible, to correct your data if these mistakes occur.

HBK’s Fusion-LN and LAN-XI data acquisition systems support TEDS technology, which recognises the connected sensor and configures the system accordingly. The system reads the sensor’s built-in memory chip and automatically applies the relevant settings and parameters.

Capture accurate data from your first measurement while reducing the risk of configuration errors.

Troubleshooting Analyser - NVH Automotive 2

Mistake #2: Skipping system verification and calibration

Cables can degrade, sensors can drift from calibrated values, and connections can loosen during operation. A damaged sensor may continue to produce plausible looking measurements, while deteriorated cables can introduce unwanted signals into the measurement data.

HBK’s BK Connect® analysis software includes built-in verification tools that help check the signal chain before testing begins. Detect cable faults, identify damaged sensors, and verify measurement accuracy.

Confirm system integrity before spending hours collecting questionable data.

Mistake #3: Using the wrong analysis type for your problem

For example, steady-state analysis can identify continuous hums effectively but may not capture transient impacts. Time recording shows when noise and vibration events occur but may need to be combined with frequency analysis to identify the frequencies involved.

The BK Connect software bundle includes multiple analysis types in one comprehensive package including FFT, octave analysis, time recording, and order tracking. Guided workflows help you select the appropriate analysis method for your specific problem.

Apply the right analysis method identify the source of the problem more effectively.

Mistake #4: Overcomplicating the setup process

When first using sound and vibration testing software, engineers may assume they need to customise every parameter before making their first measurement. This can result in unnecessary setup time and a greater risk of configuration errors.

BK Connect is designed with intelligent defaults and guided workflows for common measurement scenarios. The software’s interface guides you through the setup process, highlighting the parameters most relevant to your test.

Make meaningful measurements without unnecessary configuration complexity.

HBK Troubleshooting Analyser Graphic

Mistake #5: Not saving and reusing test setups

Engineers new to sound and vibration testing may recreate configurations for each measurement session, unaware that setups can be saved and reused. For repetitive testing, this wastes time and can introduce inconsistencies between measurements.

BK Connect makes it easy to save complete test configuration as reusable templates. For example, a regularly used electric motor test setup can be saved and reused The system preserves sensor assignments, analysis parameters, and display settings.

Make valid comparisons while reducing setup time for repeated tests.

Mistake #6: Neglecting data comparison across test runs

You’ve identified a vibration issue, made a design change, and retested the system. To determine whether the change has improved the result, you need to compare the measurements directly. Relying on separate plots or previous results makes objective assessment more difficult.

BK Connect includes comparison tools that let you overlay results from different test runs directly. The software supports before-and-after analysis with export to Word®, Excel®, and PowerPoint® for reporting.

Compare test results objectively and quantify the effect of design changes.

The path forward

Many common sound and vibration testing errors can be avoided by using the right tools and establishing a consistent measurement process.

HBK’s Troubleshooting Analyser combines BK Connect analysis software with either Fusion-LN or LAN-XI data acquisition hardware in a complete solution designed to simplify setup and troubleshooting.

The system offers automatic sensor recognition, built-in verification, multiple analysis options, guided workflows, template management, and comparison capabilities.

Want to simplify your sound and vibration testing? Visit our application page to learn more about the complete solution or contact our experts to discuss your specific requirements.  

Explore More